CMOS BATTRY:-

        The memory and real-time clock are generally powered by a CR2032 lithium coin cell. These cells last two to ten years, depending on the type of motherboard, ambient temperature and the time that the system is powered off, while other common cell types can last significantly longer or shorter periods, such as the CR2016 which will generally last about 40% as long. Higher temperatures and longer power-off time will shorten cell life. When replacing the cell, the system time and CMOS BIOS settings may revert to default values. This may be avoided by replacing the cell with the power supply master switch on. On ATX motherboards, this will supply 3V standby power to the motherboard even if it is apparently "switched off", and keep the CMOS memory energised.

Some computer designs have used non-button cell batteries, such as the cylindrical "1/2 AA" used in the Power Mac G4 as well as some older IBM PC compatibles, or a 3-cell NiCd CMOS battery that looks like a "barrel" (common in Amigas and older IBM PC compatibles), which serves the same purpose.

TYPES OF CMOS BATTRY:-

1)Resetting the CMOS settings:-To access the BIOS setup when the machine fails to operate, occasionally a drastic move is required. In older computers with battery-backed RAM, removal of the battery and short circuiting the battery input terminals for a while did the job; in some more modern machines this move only resets the RTC. Some motherboards offer a CMOS-reset jumper or a reset button. In yet other cases, the EEPROM chip has to be desoldered and the data in it manually edited using a programmer. Sometimes it is enough to ground the CLK or DTA line of the I²C bus of the EEPROM at the right moment during boot, this requires some precise soldering on SMD parts. If the machine lets you boot but does not want to let you into the BIOS setup, one possible recovery is to deliberately "damage" the CMOS checksum by doing direct port writes using debug.exe, corrupting some bytes of the checksum-protected area of the CMOS RAM; at the next boot, the computer typically resets its setting to factory defaults. for example:

c:\debug         -o 70 10          -o 71 aa           -q

2)Backup battery:-A backup battery provides power to a system when the primary source of power is unavailable. Backup batteries range from small single cells to retain clock time and date in computers, up to large battery room facilities that power uninterruptible power supply systems for large data centers. Small backup batteries may be primary cells; rechargeable backup batteries are kept charged by the prime power supply.

3)Aircraft emergency batteries:-Backup batteries in aircraft keep essential instruments and devices running in the event of an engine power failure. Each aircraft has enough power in the backup batteries to facilitate a safe landing. The batteries keeping navigation, ELUs (emergency lighting units), emergency pressure or oxygen systems running at altitude, and radio equipment operational. Larger aircraft have control surfaces that run on these backups as well. Aircraft batteries are either nickel-cadmium or valve-regulated lead acid type. The battery keeps all necessary items running for between 30 minutes and 3 hours. Large aircraft may have a ram air turbine to provide additional power during engine failures.

4)Burglar alarms:-Backup batteries are almost always used in burglar alarms. The backup battery prevents the burglar from disabling the alarm by turning off power to the building. Additionally these batteries power the remote cellular phone systems that thwart phone line snipping as well.

5)Computers:-Modern personal computer motherboards have a backup battery to run the clock circuit and retain configuation memory while the system is turned off. This is often called the CMOS battery. The original IBM AT, for example, used a small primary lithium battery to retain the clock and configuration memory. Modern systems use either primary or rechargeable batteries.  Primary batteries required periodic replacement; rechargeable types often lasted as long as the system they supported.

Backup batteries are used in uninterruptible power supplies, and provide power to the computers they supply for a variable period after a power failure, usually long enough to at least allow the computer to be shut down gracefully. These batteries are often large sealed lead-acid batteries.

Server-grade disk array controllers often contain onboard cache memory, and provide an option for a "backup battery unit" (BBU) to maintain the contents of this cache after power loss. If this battery is present, disk writes can be considered completed when they reach the cache, thus speeding up I/O throughput by not waiting for the hard drive. This operation mode is called "write-back caching".

6)Hospitals:-Power failure in a hospital would result in life threatening conditions for patients. Patients undergoing surgery or on life support are reliant on a consistent power supply. Backup generators or batteries supply power to critical equipment until main power can be restored.